Avaliação da vibração aplicada em seccionador vertical reverso utilizando o método dos elementos finitos

• Ano de defesa: 2019
• Autor(a) principal: Mores, Maira Andréia Luckmann
• Orientador(a): Meira Júnior, Agenor Dias de
• Tipo de documento: Dissertação
• Tipo de acesso: Acesso aberto
• Idioma: por
• Instituição de defesa: Universidade de Passo Fundo
• Programa de Pós-Graduação: Programa de Pós-Graduação em Projeto e Processos de Fabricação
• Departamento: Faculdade de Engenharia e Arquitetura – FEAR
• País: Brasil
• Palavras-chave em Português: Processos de fabricação; Circuitos elétricos; Dispositivos eletromecânicos; Método dos elementos finitos
• Área do conhecimento CNPq: ENGENHARIAS::ENGENHARIA CIVIL
• Link de acesso: http://tede.upf.br:8080/jspui/handle/tede/1858

The Disconnector is a switching device used in Substations, which connects the electrical circuit to the Substation and allows the protection of the system. Within a Substation, the ideal is that the equipment has remote activation. But in the case of the Disconnector, its drive is partially automated, as it may happen that the closing maneuver is not completed. In order to complete the closing of the electrical contacts remotely, there is a solution which consists in to fix an electromechanical vibration motor to the disconnector structure. The vibration produced by this device is transmitted to the main contacts, reducing the friction and residual stresses of the mechanisms, promoting their closure. To test this solution, a detailed three-dimensional model of the structure was made, and the analysis was done with a program that uses the Finite Element Method. The objective of the analyzes was to study the frequency of excitation of the electrical contact of the disconnector, to evaluate how the support structure of the disconnector behaves with the excitation that causes the contacts to fit, and to determine the frequency of the activation of the vibration motor electromechanical. After the threedimensional model was finalized, the boundary conditions were applied with the Ansys Workbench Ls-Dyna Software, and the natural frequencies of the system were identified. In order to validate the model, an experimental test was carried out to verify the natural frequencies. The values of natural frequencies were used to study the excitation of the electric contact, and a frequency value was obtained that produced good results in the displacement of the mobile contact, which was used to make several simulations in the Software. And with the simulations it was possible to evaluate the behavior of the structure with the vibration, and to determine the drive frequency and torque of the electromechanical vibration motor.