Modulação space vector para conversores multiníveis com células assimétricas em cascata sob condições de faltas

Detalhes bibliográficos
Ano de defesa: 2015
Autor(a) principal: Carnielutti, Fernanda de Morais
Orientador(a): Não Informado pela instituição
Banca de defesa: Não Informado pela instituição
Tipo de documento: Tese
Tipo de acesso: Acesso aberto
Idioma: por
Instituição de defesa: Universidade Federal de Santa Maria
BR
Engenharia Elétrica
UFSM
Programa de Pós-Graduação em Engenharia Elétrica
Programa de Pós-Graduação: Não Informado pela instituição
Departamento: Não Informado pela instituição
País: Não Informado pela instituição
Palavras-chave em Português:
Link de acesso: http://repositorio.ufsm.br/handle/1/3694
Resumo: This Thesis proposes a Space Vector Modulation for cascaded miltilevel converters with asymmetric cells under normal conditions and with faults in the power cells, avoiding converter saturation as much as possible. The switching state vectors and the voltage references are represented in the output line-to-line voltages coordinate system. Under this representation, the switching state vectors have only integer entries, easing the implementation of the proposed algorithm. The modulation is developed in a way such as to guarantee that the higher voltage cells switch at low frequency by the choice of only one vector per switching period, minimizing the switching losses. For the lower voltage cells (1pu), that switch with PWM, three algorithms were developed for defining the switching sequences: (i) offline, (ii) online and (iii) hybrid, where a carrier-based geometrical modulation and the SV are mixed in a simple and unified approach. The algorithm is described in a generic way, for converters with any number of levels, and then, simulation and experimental results are shown for, respectively, cascaded miltilevel converters with asymmetric cells with DC bus voltages ratio of 1:2:4pu and 1:2pu. The algorithm does not use conventional separation lines to find where the multiple references for the power cells are located inside the SV diagram. It also avoids converter saturation and, when it is unavoidable, detects its occurrence and changes the operation mode to overmodulation. This one is treated as a modification of the orignal algorithm, allowing the converter to operate with a wider range of modulation indexes and fault conditions. It is shown that two overmodulation modes can occur: in the first, there is still an area inside the SV diagram where overmodulation is avoided, and, in the second, the converter overmodulates during almost all the time. Modulation strategies are proposed for both cases, including the insertion of a bandpass filter in the second case, so as to minimize the distortions and unbalances that arise on the converter output line-to-line voltages during this operation mode. For the overmodulation, simulation and experimental results are also shown for cascaded miltilevel converters with asymmetric cells with DC bus voltages ratio of 1:2:4pu and 1:2pu. Finally, the final conclusions are drawn and future works are proposed.