Create Cost Effective Post Processing Techniques for Multiple Measured and Simulated Components of CVT Transmissions

• Autor(a) principal: Martins, Luís António Salvador
• Data de Publicação: 2018
• Tipo de documento: Dissertação
• Idioma: eng
• Título da fonte: Repositórios Científicos de Acesso Aberto de Portugal (RCAAP)
• Texto Completo: http://hdl.handle.net/10400.22/12675
• topic: Continuously Variable Transmission; Hydraulic Block; Gear Measurements; Road Load Data Acquisition; Programming; Algorithms; Transmissão Continuamente Variável; Bloco Hidráulico; Medições em Rodas Dentadas; Aquisição de Dados de Carga em Estrada; Programação; Algoritmos

The automotive industry requires continuous innovation in order to fight the high competitiveness in this sector. More than ever, fuel economy, low emissions and comfort are the main goals when designing a vehicle. Continuously Variable Transmissions (CVT) are a type of transmissions that meet with those features and it can be the future of automatic transmissions. The presented dissertation was developed during an internship in a company, specialist in the development and production of CVT transmissions, designated by Punch Powertrain NV, located in Sint-Truiden, Belgium. The work was incorporated in the Research and Development (R&D) department, in the team of simulation, where it was possible to enhance the academic experience. This work is based on a need to post-process the results of several measured and simulated scenarios. Firstly, it was proposed to analyse the interference between the components of a hydraulic block. After the block is simulated individually, the inside walls can deform and it is important to analyse if there is interference with the movable components. Secondly, there are corrections done on gears. These corrections are evaluated through gear measurements, which need to be processed to determine if the modifications are within the nominal parameters. The last task was to analyse exported data from road load tests. In each transmission, five accelerometers are installed that record the loads subjected in the three coordinates. These files are read and, then, processed using an algorithm of a counting method, that can predict the cycles of each accelerometer for the different loads. All results are validated by the team leader and the specialists of each field. In the end, the internship allowed to increase the knowledge obtained from the Master’s.