Study of resistance welded composite joints: from the manufacturing process to the mechanical behaviour

• Ano de defesa: 2013
• Autor(a) principal: Angélico, Ricardo Afonso
• Tipo de documento: Tese
• Tipo de acesso: Acesso aberto
• Idioma: eng
• Instituição de defesa: Biblioteca Digitais de Teses e Dissertações da USP
• Palavras-chave em Português: Composite joints; Compósitos termoplásticos; Juntas compósitas; Resistance welding; Soldagem por resistência; Thermoplastic composites
• Link de acesso: http://www.teses.usp.br/teses/disponiveis/18/18148/tde-14122017-111250/

This study is dedicated to thermoplastic composite joints obtained by an electrical resistance welding procedure. This welding process consists in joining two substrates with an electrical resistor which acts as a heating element melting the polymer substrates. The substrates considered herein are 2mm thick 7-layer hybrid composites, with the following stacking sequence ([0°/90°]G, [0°/90°]C, [45°]C, [0°/90°]C, [45°]C, [0°/90°]C, [0°/90°]G), where G and C denote plies with PPS matrix reinforced by continuous glass or carbon bres, respectively. The heating element is a stainless metallic grid surrounded by two PPS amorphous lms. For a better understanding of the the time evolution of the temperature eld in the welded zone, a heat transfer model was developed in nite element code Abaqus®. The prediction capabilities of the numerical tool were validated by comparing the numerical results with thermocouple measurements. The thermal properties required by the nite element model, viz. the specic heat and the thermal conductivities, were identied from DSC tests and from an inverse identication procedure, respectively. The inverse identication procedure is based on a Levenberg-Marquart algorithm applied to the analysis of specic experiments instrumented with thermocouples and an infra-red camera. Thermal or/and mechanical analyses of anisotropic composite laminates can lead to high computational costs even for linear analyses. Proper Generalized Decomposition constitutes a promising tool to reduce computational costs for multi-dimensional problems such as multi-parametric problems typical of manufacturing process simulations and/or problems with dierent length scales typical of composite laminates. To demonstrate its capabilities and its eciency {including in terms of computation costs for small size problems- PGD technique is applied to the solution of an axisymmetric heat transfer problem. Specimens were manufactured (with a laboratory welding machine designed and built during this study) with dierent processing parameters - eating element geometry, intensity of the electrical current, time evolution of the pressure. DCB specimens were tested to characterize the mechanical toughness under mode I. The analysis with the compliance method of the tests results exhibits two non-negligible energy dissipation mechanisms, related to crack creation and localized plastic deformation, respectively. An original model developed within the internal variable thermodynamics framework is proposed and used to describe the R-curves representative of the ductile behaviour of the DCB specimens. A rst sensitivity analysis of the processing parameters on the joint fracture toughness exhibits the key role of the pressure applied onto the joint during the cooling phase of the welding process.