Study of catalysts for the hydrodeoxygenation reaction of phenol

Detalhes bibliográficos
Ano de defesa: 2017
Autor(a) principal: Resende, Karen Abreu
Orientador(a): Não Informado pela instituição
Banca de defesa: Não Informado pela instituição
Tipo de documento: Tese
Tipo de acesso: Acesso aberto
Idioma: eng
Instituição de defesa: Universidade Federal de Uberlândia
Brasil
Programa de Pós-graduação em Engenharia Química
Programa de Pós-Graduação: Não Informado pela instituição
Departamento: Não Informado pela instituição
País: Não Informado pela instituição
Palavras-chave em Português:
Link de acesso: https://repositorio.ufu.br/handle/123456789/20633
http://dx.doi.org/10.14393/ufu.te.2017.6
Resumo: The conversion of biomass into bio-oil through fast pyrolysis followed by its upgrading via hydrodeoxygenation (HDO) is considered a potential route for the production of renewable fuels. The present work aimed to develop new catalysts for the hydrodeoxygenation (HDO) of phenol, which is a typical bio-oil model compound. The work section was divided in 5 independent chapters: (i) a thermodynamic study in order to determine the most favorable operational conditions for the HDO of phenol. According to this study when methane was added to the system, the equilibrium composition calculated indicated only the formation of methane for all the conditions evaluated. However without CH4, the best operational conditions to perform the phenol HDO reaction are at intermediate temperatures and with high H2/phenol ratio; (ii) In sequence, the effect of to the addition of a second metal (Cu, Ag, Zn, Sn) on the performance of Pd/ZrO2 catalyst for HDO of phenol in the gas phase was studied. The incorporation of dopants to Pd/ZrO2 resulted in the formation of Pd–X (Cu, Ag, Zn) alloys, which reduced the reaction rate for HDO and increased the selectivity to hydrogenation products (cyclohexanone and cyclohexanol). However, the oxophilic sites generated by Sn cations promoted the hydrogenation of the carbonyl group of the keto-tautomer intermediate formed, producing benzene as the main product; (iii) The impact of particle size of ZrO2-supported Pd and of alloying with Ag was explored for hydrogenation of phenol in aqueous phase. This study was performed during an internship at PNNL (Pacific Northwest National Laboratory). Kinetic assessments were performed in a batch reactor, on monometallic Pd/ZrO2 samples with different Pd loadings (0.5%, 1% and 2%), as well as on a 1% PdAg/ZrO2 sample. In general, the lower activity of the small Pd particles was attributed to low activation entropies for the strongly bound species and the presence of Ag increases catalyst activity by decreasing the apparent energy of activation and increasing the coverages of phenol and H2, without negatively affecting the transition entropy; (iv) After that, based on the recent insides reported about the HDO reactions, the hydrodeoxygenation of phenol was studied using Rh, Pd and Ni catalysts supported on Nb2O5. This part allowed understanding how the SMSI (strong metal-support interaction) affects the selectivity of the HDO reaction. In general, an increase in the reduction temperature favored benzene selectivity, all the samples showed selectivity of approximately 95% for benzene for high reduction temperatures; (v) In the final chapter of this work the effect of doping cerium oxide support with niobium was investigated for HDO of phenol at 573K in the gas phase. The incorporation of niobium altered the lattice parameters of cerium based oxides, favored the reduction of the cerium and increased the selectivity to deoxygenated products (benzene). Small amounts of niobium affected the surface area of the support and promoted the formation of more dispersed nickel particles, which disfavored the hydrogenolysis of benzene. In general, the data presented in this thesis contributed to a better understanding of the HDO reaction. Keywords: hydrodeoxygenation, phenol, bimetallic, thermodynamics, niobium, oxides.