Desenvolvimento e aplicação de um sistema com arco elétrico para SS-FF AAS para a determinação de impurezas elementares

Detalhes bibliográficos
Ano de defesa: 2020
Autor(a) principal: Santos, Rafael Francisco dos
Orientador(a): Não Informado pela instituição
Banca de defesa: Não Informado pela instituição
Tipo de documento: Tese
Tipo de acesso: Acesso aberto
Idioma: por
Instituição de defesa: Universidade Federal de Santa Maria
Brasil
Química
UFSM
Programa de Pós-Graduação em Química
Centro de Ciências Naturais e Exatas
Programa de Pós-Graduação: Não Informado pela instituição
Departamento: Não Informado pela instituição
País: Não Informado pela instituição
Palavras-chave em Português:
Link de acesso: http://repositorio.ufsm.br/handle/1/23096
Resumo: An alternative system for solid sampling and element determination by heated tube coupled to flame atomic absorption spectrometry was developed for the determination of Cd, Co, Mo, Ni and Pb in high purity graphite and carbon nanotubes (CNTs). Three quartz systems were developed and evaluated: without atomizer tube (system A) and with atomizer tube, being one of them of 80 mm of length without slit (system B) and other with the same length and with a 80 mm slit (system C) that allow the flame inlet. Two electrodes were positioned in the system and were connected to an external device, to generate an electric discharge which was responsible to ignite the samples. Samples were introduced in the system, with ethanol as auxiliary reagent to start the combustion before the generation of arch discharge between electrodes, in the presence of a constant O2 flow, that was responsible to react with organic matrix producing CO2 as main product and driving the gaseous products of combustion with the analytes to the atomizer tube. The system B was the most suitable having a quartz atomizer tube connected to a perpendicular tube (“T” shape). This atomizer tube was positioned over the spectrometer flame and acted as an atom trap to increase the atomic density in front of the optical beam, reducing the limits of detections (LODs). The following parameters were investigated to optimize the system: flame stoichiometry of air/acetylene (620/100, 565/100, 430/100 and 400/120 L h-1), distance between atomizer tube and burner (3, 6, 9, 12 e 15 mm), O2 flow-rate (0.3, 0.5, 1.0 and 2.0 L min-1), linear calibration range and the sample mass influence in the determination. The calibration was performed by matrix matching, being added the analyte to a high purity graphite, used as a standard, and the results were statistically compared with reference values obtained by inductively coupled plasma optical emission spectrometry (ICP-OES) and by inductively coupled plasma mass spectrometry (ICP-MS) before decomposition of samples by microwave-induced combustion (MIC). The proposed method allows the introduction of up 50 mg of solid sample, without a sample decomposition for the determination of Cd, Ni and Pb in graphite and CNTs. Low LODs were achieved for the SS-FF AAS system (between 0.107 and 4.20 μg g-1), allowing the determination of analytes at low concentrations. Moreover, the proposed method agreed with several recommendations of green analytical chemistry as reduced sample pre-treatment, low sample consumption, no use of toxic reagents for sample preparation, low residues generation (basically CO2), low electric energy consumption and relatively safety for the analyst.