Detalhes bibliográficos
| Ano de defesa: |
2015 |
| Autor(a) principal: |
Prudente, Carolina Queiroz Arantes |
| Orientador(a): |
Rezende, Lilian Ribeiro de
 |
| Banca de defesa: |
Rezende, Lilian Ribeiro,
Mascarenha, Márcia Maria dos Anjos,
Angelim, Renato Resende |
| Tipo de documento: |
Dissertação
|
| Tipo de acesso: |
Acesso aberto |
| Idioma: |
por |
| Instituição de defesa: |
Universidade Federal de Goiás
|
| Programa de Pós-Graduação: |
Programa de Pós-graduação em Geotecnia, Estruturas e Construção Civil (EEC)
|
| Departamento: |
Escola de Engenharia Civil - EEC (RG)
|
| País: |
Brasil
|
| Palavras-chave em Português: |
|
| Palavras-chave em Inglês: |
|
| Área do conhecimento CNPq: |
|
| Link de acesso: |
http://repositorio.bc.ufg.br/tede/handle/tede/5273
|
Resumo: |
Flexible or asphalt pavements compose the Brazilian highway network, which have to promote security on traffic on the highways, to support the effects of changes in climate and to resist the traffic of vehicles. By this reasons, the structure of the pavement is particularly important and must be constituted by layers, which can distribute the loads into the structure, reducing the vertical load produced by the action of traffic and, consequently, providing protection to the subgrade. In the middle western Brazil, in the state of Goiás, there is not advanced studies on asphalt mixtures used in highways and in urban pavements, and there is not a technical scientific proofing that the local aggregates available in the region, is the best option considering the local conditions. Forward better conditions of infrastructure, it is proposed to develop more efficient asphalt mixtures for pavements, by submitting the mixtures through analysis of mechanical strength and performance test, analyzing if the most used asphalts mixtures are satisfactory or not. The hot asphalt mixture are composed by aggregates and asphalt binders that are design in order to attend the parameters set in the projects according to demand and traffic types. In this research, it was proposed the study of six asphalt mixture design with different types of asphalt binders with the same aggregates origin in a different grain size range (Bands B and C). The binders used in this study are the conventional cement asphalt in the region, CAP 30/45 e 50/70 (Brazilian penetration grade), with low and medium penetration, respectively, and the polymer modified asphalt (AMP). The CAP 50/70 is the most used conventional binder in the region, followed by CAP 30/45. Tha AMP binder is not often used. The characterization tests of the materials that composed the mixture are presented and their selection and characterization attended the standardized procedures and requirements by the brazilian department responsible for highway structures (DNIT). In a second stage, the design tests were performed, combining aggregates and binders in different rates, by the Marshall Mix Design Method using manual compression, until the great design was obtained The laboratory tests were realized with this great design to analyze the mass loss and obtain its mechanical properties, given by the tensile strength (RT). Performance tests were realized to obtain its resilient modulus (MR) and, using wheel tracking test, to obtain the permanent deformation (DP). The results showed that the common hot mixture asphalt used in the region (range C and CAP 50/70), is not a good option, because its performance is not satisfactory. Therefore, the range to be used, and the binder, must be analyzed for each traffic level. It is also recommended to evaluate the Marshall methodology for design mixtures, considering mainly the compression way and the determination of the maximum densities. |
