O efeito da carga normal no comportamento tribológico de uma superliga de cobalto no ensaio pino-disco

Detalhes bibliográficos
Ano de defesa: 2014
Autor(a) principal: Tauffer, Renato Leão
Orientador(a): Não Informado pela instituição
Banca de defesa: Não Informado pela instituição
Tipo de documento: Dissertação
Tipo de acesso: Acesso aberto
Idioma: por
Instituição de defesa: Universidade Federal do Espírito Santo
BR
Mestrado em Engenharia Mecânica
Centro Tecnológico
UFES
Programa de Pós-Graduação em Engenharia Mecânica
Programa de Pós-Graduação: Não Informado pela instituição
Departamento: Não Informado pela instituição
País: Não Informado pela instituição
Palavras-chave em Português:
621
Link de acesso: http://repositorio.ufes.br/handle/10/1810
Resumo: It has been reported in the literature that the wear and the friction coefficient (μ) in sliding wear tests of cobalt-base alloys is strongly influenced by the phase transformation (FCC to HCP) that takes place in these alloys due to mechanical work. Usually the values of μ, after the transformation, are in the range of 0.15-0.20. The present work reports the behavior of friction and wear for the unlubricated sliding of a supermartensitic stainless steel pin on an as-cast Co-base superalloy disk, using a PLINT TE-67 tribometer. The tests were conducted at room temperature, using a single sliding speed and varying the normal load (5-500 N). The coefficient of friction and the contact potential were monitored during the tests. Scanning electron microscopy (SEM) and 3D profilometry were used to characterize the wear volume and wear mechanisms. For loads ranging from 350 to 450 N, after achieving steady-state conditions, an unusual very low friction coefficient (μ<0.01) and low wear rate were found. The X-ray diffraction analysis on the wear track revealed the mentioned transformation.