Detalhes bibliográficos
| Ano de defesa: |
2010 |
| Autor(a) principal: |
Alves, William Ferreira |
| Orientador(a): |
Mattoso, Luiz Henrique Capparelli
 |
| Banca de defesa: |
Não Informado pela instituição |
| Tipo de documento: |
Tese
|
| Tipo de acesso: |
Acesso aberto |
| Idioma: |
por |
| Instituição de defesa: |
Universidade Federal de São Carlos
|
| Programa de Pós-Graduação: |
Programa de Pós-Graduação em Química - PPGQ
|
| Departamento: |
Não Informado pela instituição
|
| País: |
BR
|
| Palavras-chave em Português: |
|
| Área do conhecimento CNPq: |
|
| Link de acesso: |
https://repositorio.ufscar.br/handle/20.500.14289/6170
|
Resumo: |
The incorporation of conducting polymer into a conventional polymer matrix has received considerable attention in the last decade because of the possibility of combining the good processability and mechanical performance of the conventional polymer with the electrical optical properties of conducting polymer. Among conducting polymers, polyaniline (PANI) and its derivatives has been extensively used because of the low cost of raw material, ease of synthesis and environmental stability. The main objective of this study was to develop a sensor for electronic tongue, from thin films of blends of polyurethane with POMA on interdigitated electrodes produced by spin-coating technique, under optimized conditions, and check the electrical behavior of the sensors in states doped. Films PUR mixture with POMA, although they may have less sensitivity to the substances found in the analyte than the nano-structured films, they may have better adherence and therefore be used to analyze substances with which the nano-structured films would not be possible. Films mixture of polyurethane derived from castor oil (PUR) and POMA were obtained by the casting (free standing) and also on interdigitated electrodes by the method of spin coating. The films were characterized using the techniques of UV-Vis-Nir, thermo-dynamic-mechanical analysis (DMTA), thermogravimetric analysis (TGA), stress-strain and optical microscopy. The values of modulus of elasticity of the PUR solvent chloroform (PUR-Clo) for the mixture of PUR/POMA (m/m) 50/50 had values of 0.3 GPa and 4.1 GPa, respectively. With the incorporation of 10% of POMA in the PUR glass transition temperature (Tg) of the films increased from 67 to 137oC, respectively. For the analysis done by DMA, the films with 30, 40 and 50% of POMA in PUR, confirmed the presence of crosslinking between the polymers, Mc, values of 195, 322 and 517 mol/m3, respectively. The films doped with NH4OH and HCl have better response capacitive and resistive to various analytes analyzed in the frequency range 1-105 Hz Thus, the sensors doped and dedoped can be used as an identifier of fingerprint detection of substances in different concentrations. |
