Evaluation of TI-6AL-4V friction surfacing coatings reinforced with carbides

• Ano de defesa: 2017
• Autor(a) principal: Feliciano, Carlos Alberto Belei
• Orientador(a): Alcântara, Nelson Guedes de
• Tipo de documento: Dissertação
• Tipo de acesso: Acesso aberto
• Idioma: eng
• Instituição de defesa: Universidade Federal de São Carlos; Câmpus São Carlos
• Programa de Pós-Graduação: Programa de Pós-Graduação em Ciência e Engenharia de Materiais - PPGCEM
• Palavras-chave em Português: Soldagem por fricção; Deposição por fricção; Compósitos de matriz metálica
• Área do conhecimento CNPq: ENGENHARIAS::ENGENHARIA DE MATERIAIS E METALURGICA::INSTALACOES E EQUIPAMENTOS METALURGICOS
• Link de acesso: https://repositorio.ufscar.br/handle/20.500.14289/9532

Friction surfacing is a thermo-mechanical process employed to deposit coatings in solid state resorting to friction between a rotating consumable rod and a substrate. The current work focuses on deposition of Ti-6Al-4V coatings reinforced with carbide particles (TiC, B4C and SiC) on Ti-6Al-4V substrate. Particles were added using holes drilled into the rod tip. Different configurations of hole placements within the rod were correlated with process behavior, coating quality, deposition efficiency and particle distribution within the deposits. Configurations varied in number of holes and their distance to the rod’s cross-sectional center. Holes placed near to the rod center increased axial forces during the plastification stage, whereas particles in holes far off the rod center were mainly expelled, not yielding as much effect on the process response. An increase in number of holes amplified the effects of the hole distance. The axial force during plastification stage affected both coating appearance and process efficiency. No full intermixing of coating material and particles during deposition occurred, thereby preventing a uniform distribution of particles throughout the coatings. Particles were mostly deposited along trails, which influenced the behavior of growing grains during recrystallization. B4C and SiC particles underwent dissolution, whose degree was influenced by the rotational speed. Moreover, a refined α-Ti microstructure was reported, related to the development of shear bands independent of the particles’ presence.